NSEE AM-KP1 433MHz Universal Wireless Keypad w/ Receiver Weatherproof 2-Channel

Description

Product overview
--Power supply: DC 6V ( 4pcs AAA 1.5v dry battery).
--Touch keyboard: 1-9, *, 0, #.
--Standby current: 18uA (Sleep mode), 6mA ( working mode).
--Working current: 28mA ( working mode).
--Three LED indicator light: Red, Green, Blue.
--Low battery indication: If the battery is low, keypad would have beep indication after every signal transmission is made.
-- Anti-vandal alarm. When the keypad is disassembled illegally, the buzzer will “beep” to alert.
-- 4 digits installer’s pin code and 4 digits user’s pin code setting.
-- RF learning code function: can learn commonly used fixed code, HCS301 rolling code.
-- Two channels RF 433MHZ transmitting.
-- Scrambled pin code.
-- Keypad buzzer on/off.
-- Keypad back light on/0ff.
-- Keypad security lock.
-- Factory default setting
-- Weatherproof
-- Keypad can learn frequency from Remote control, (Fixed and some rolling codes, if you have problems with your remote use the receiver included)
---------------
Receiver Specs
12-24V AC/DC
Memory Capacity: 200 codes
Temperature: -25 ～+85 degree centigrade Static current: 5mA+/-2
2. Operation
1. Remove the 2 screws on the back of the receiver and lift off the cover.
2. Connect the two power supply wires, one to 12-24V and the other AC/DC.
3. When the power is initiated the LED will light for 1 second and the receiver is ready for instructions.
4. LEARNING CODE: Press P1 for at least 1 second, the LED will light for 1 second, go off for 1 second and then light again, press any button on the remote, if the code is learnt successfully, the LED will blink; then release the button on the remote, the LED will be OFF. If the remote cannot read the signal, the LED will light for 10 seconds and finish its learning status.
5. PROGRAMMING METHOD:
A. Press P1 once, the LED flashes once and the first channel (monostable) activates.
B. Press P1 twice, the LED flashes twice and the second channel (monostable) activates.
C. Press P1 three times, the LED flashes three times and the first channel (bistable) activates.
D. Press P1 four times, the LED flashes four times and the second channel (bistable) activates.
6. DELETING FUNCTION:
A. Deleting one code: Press P2 for approximately 3 seconds, the LED will light, press the button of the code you no longer require and the code will be deleted.
B. Deleting all codes: Press P2 for 8 seconds or until the LED lights, release the button and the LED will go off, all codes will have been deleted.